Lighting Installation & Repair

How We Plan A Lighting Project

A good lighting install isn't just about the hardware—it's about where the fixtures go and how they're controlled.

Walkthrough

We start by hearing your ideas and understanding your goals. Then we suggest fixture counts and placements that make sense for the space.

Switch & Wiring Plan

We plan for switch types and locations, then map out any wiring work needed to support the layout. Everything is done to code with the right boxes, circuits, and load calculations.

Fixture Selection

You either pick the fixtures yourself or we point you to our suppliers. No markups—you pay what we pay.

Install & Control Setup

We mount, wire, and test all fixtures. If you're using dimmers or smart switches, we program and verify those too.

---

Lighting Repairs

Flickering lights, dead switches, or fixtures that won't turn on—we diagnose and fix the problem. That might mean replacing a ballast, rewiring a junction box, or swapping out a failed dimmer. We carry common parts on the truck so most repairs are done the same visit.

---

Code Compliance

All installations meet NEC requirements and local Brick Township codes. We pull permits when required and coordinate inspections.